Australian Spa Parts

Aquatemp in-line spa heater tube - Suits S&P Opal 2500 and Opal 5500 as well as a few other models. Many other combinations and styles in stock - please supply digital photo and dimensions for other tubes such as Gecko,...

Aquatemp Spa Heater Uni-Nut Retainer Collar - fits against heater tube flange and prevents nut sliding off.This collar is split to allow fitting over the flange on the tube

Heater tank/body to suit Bowman 6kw spa heaters

Suits Heaters from Gecko, Aquatemp, Balboa, RMF, Hydroquip, some Spaquip and others

240v, 30A 2 pole contactor - found in Aquatemp, Paramount, Balboa, Signature Spas and many other controllers

Combination gasket and o ring in one for superior seal - installed each end of the heater tubeCan be used on many brands with similar mounting - suits Gecko, Hydroquip, Balboa, Aquatemp, RMF, etc Sold as a...

Electric Spa Heater Contactor - Used on all Dega / Onga 3 phase heaters - 15kw (x1), 24kw (x2), and 30kw(x2)

3 x O-Rings to suit spaquip ampac pulsar 40mm heater tee - 2 x 40mm o-rings, 1 x heater element o-ring.

Used on 40mm Spaquip unions as well as new 50mm Heater Tees in conjunction with a Heater Element O-Ring and a 50mm union O-Ring (40mm heater tees use 2 x 40mm union o-rings and 1 x heater element o-ring)

Older style obsolete heater tee with fine threads on the tee ends and 50mm male union thread - usually found used in conjunction with a short riser tube above the pump. Suits Pulsar series controllersNO LONGER...

Used on 50mm Spaquip unions as well as new 50mm Heater Tees in conjunction with a Heater Element O-Ring and a 40mm union O-Ring

Suits Spaquip Classic range of spa heaters - the element screws through this part, as does the pressure switch nipple. The heater tank body o-ring seats around the outside of this part

Not the same as an Aquatemp Uni-Nut Retainer - thes are used on Spaquip Pulsar, Intuitive, Impulse series heater element cones as a retainer for the heater union nut. The red and black rings suit 2 different styles of...

Available with push on spade terminals or screw down terminals - used in Spaquip Classic heaters and can be used on all single pole spa heaters (6kw max)Rated at 240v, 30A AC1 resistive load.

Covers the rear of the element assy on spaquip pulsar style elements - has a hole for the reset rod - held on with 2 x 5.5mm nuts

This spaquip heater dome dust gasket is stuck to the cone/retainer face behind the element.(This is not the o-ring seal !)

Portapac element quad-ring o ring seal