Zink (Ethink) KL8890 Spa control system. 9 way Touchpad, suits Gas Heater, Heat Pump or Heat Exchanger
Zink KL8890 series spa control system with 9 way touchpad, to suit separate gas heater or heat pump
Zink KL8800 control box,
Zink KL8890 9 button touchpad.
Zink temperature/flow sensor union
Zink 5 pin AMP plug and 3 AMP pins for gas heater/heat pump connection
Touchpad size - 182mm x 66mm
Can be programmed and configured to run 1-3 jet pumps plus blower, ozone, light and circulation pump.
1. Pump 1: Single speed with or without Circulation Pump, or Two Speed
2. Pump 2: single speed
3. Pump 3: single speed
4. Blower: single speed
5. Ozone: 240v or Ethink 12v unit.
6. Light: any 12v AC incandescent lamp or LED lamp up to 12w/1A, either 2 wire 12v AC or 4 wire Zink 12v DC
7. Auxillary output for stereo power supply connection or optional Zink Bluetooth module.
7. Heater: Separate gas heater, heat pump, or heat exchanger
AMP cables included for pumps, etc.
An additional Subpanel 'B' can be added for touchpad control from the other side of the spa to operate Pump 1, Pump 2, Pump 3, Blower.
The KL8800 series spa packs can be set to minimum or maximum load shed via a DIP switch on the circuit board.
With an external heater this should be set to Minimum load shed only - the heater will disable if a third pump (if fitted) is turned on. In this setting you will likely require a min 25-32A circuit if there are 3 jet pumps.
Zink KL8800 control box and heater must be weather and splash protected. Ensure they are installed in a well ventilated, dry location, preferably under the spa.
2 year return to base equipment warranty covers repair or replacement of any component that fails due to manufacturing defect within 2 years of sale to the consumer.
If you wish us to assist in ensuring the spa pack is correctly suited to your spa / system replacement, please complete the list of questions above.
If you choose not to complete the questions, we will still process your order, assuming you have correctly determined suitability to match your spa requirements.
If there is no option in the list for an output fitted to your spa, either the system configuration you are viewing doesn't support it, or it needs to be controlled in a different manner.
eg if there is no option for advising Pump 3 details, its likely the system in this configuration does not support a 3rd pump. The type of touchpad does dictate how many pumps are supported.